Carregant...
Carregant...

Vés al contingut (premeu Retorn)

Modelling of surface finish and material removal rate in rough honing

Autor
Buj, I.; Joan Vivancos-Calvet; Coba, M.
Tipus d'activitat
Article en revista
Revista
Precision engineering - Journal of the American Society for Precision Engineering (ASPE)
Data de publicació
2014-01
Volum
38
Número
1
Pàgina inicial
100
Pàgina final
108
DOI
https://doi.org/10.1016/j.precisioneng.2013.07.009 Obrir en finestra nova
Projecte finançador
New design and manufacturing processes for high pressure fluid-power products
Resum
In the present work influence of different parameters of the rough honing process on surface roughness and material removal rate were studied. Specifically, second order mathematical models are presented for mean average roughness Ra (µm), maximum peak-to-valley roughness Rt (µm) and material removal rate Qm (cm min-1), obtained by means of regression analysis. For doing this a central composite design was defined, with a full two-level five variables design of experiments, 5 centre points and...
Paraules clau
Honing, Material removal rate, Roughness
Grup de recerca
TECNOFAB - Grup de Recerca en Tecnologies de Fabricació

Participants

  • Buj Corral, Irene  (autor)
  • Vivancos Calvet, Joan  (autor)
  • Coba Salcedo, Milton  (autor)