Carregant...
Carregant...

Vés al contingut (premeu Retorn)

Influence of the injection moulding parameters on the cellular structure and thermo mechanical properties of ethylene-propylene block copolymer and PETG foams

Autor
Arencon, D.; Sanchez-Soto, M.; Martinez, A.; Gómez-Gómez, J.F.; Rodríguez, J.; Salazar, A.
Tipus d'activitat
Presentació treball a congrés
Nom de l'edició
10th International Conference on Foams Materials & Technology
Any de l'edició
2012
Data de presentació
2012-09-13
Llibre d'actes
FOAMS 2012
Repositori
http://hdl.handle.net/2117/16802 Obrir en finestra nova
URL
http://www.4spe.org/pfn/ Obrir en finestra nova
Resum
Microcellular injection moulding technology is capable of producing lightweight polymeric products. Microcellular foams are characterised by cell densities in the order of 109-1015 cells per cm3 and cell sizes between 10-100 μm in diameter. The foam morphology is determined by the injection moulding parameters, and it has been observed that depending on the parameters variations, cell structure may exhibit substantial morphological differences through the entire section, along the melt flow dir...
Citació
Arencon, D. [et al.]. Influence of the injection moulding parameters on the cellular structure and thermo mechanical properties of ethylene-propylene block copolymer and PETG foams. A: International Conference on Foams Materials & Technology. "FOAMS 2012". Barcelona: 2012.
Grup de recerca
POLY2 - Polyfunctional polymeric materials
e-PLASCOM - Plàstics i Compòsits Ecològics

Participants